0
How do you change front brake drums on a 1966 dodge coronet including removing the old lug bolts from the old drum?
Wiki User
∙ 15y ago
Take the tire off then remove the center hub off the drum, pull out cotter pin, remove the nut, pull the outer wheel bearing out and pull the drum off, to get the wheel studs out lay the drum on a flat surface and smack the studs with a hammer until you drive them out.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change shocks on a 2001 jeep grand Cherokee?
By removing the bolts.
How do you remove Lug bolts on 68 Coronet?
pound them out with a hammer.
How do you change the front brake rotors on a 1990 Toyota 4X4 pickup?
You have to take the rotor and hub off as one unit by removing the various little bolts and locks involved, including the outer wheel bearing. After removing the hub turn it over and you will see some bolts which hold the rotor onto the hub. Undo those and the rotor will drop off.
How do you change an alternator on a 92 Maxima?
The alternator on a 92 Nissan Maxima is changed by disconnecting the wiring harness, loosening the retaining bolts, and removing the drive belt. The bolts can then be fully removed and the alternator swapped out.
Do you have to take out the motor to change water pump?
not realy, its a matter of removing the pulley then the bolts, if this is the 1.0L engine. it is however tight getting at it on some models.
Where is the water pump located on a 1998 Monte Carlo and how hard is it to change?
its located behind one of the pulleys that is driven by the belt. usually the top/ front one that has 4 bolts holding it on. loosen the bolts brfore removing the belt. (this helps make it easier). 2nd remove the belt by removing tension from the belt tensioner. 3rd finish removing the 4 bolts you already loosened and remove the pulley. 4th, the water pump is held on by 5 10mm bolts remove those and install the new part reversing this procedure.
How do you remove the mirror cover on a 2006 f-250?
The mirror cover can be removed by removing the mirror cover retaining bolts. You can access the retaining bolts by removing the inside door panel.
How do you put in a 2004 dodge ram 2500 water pump?
Will the rad need to be removed to make room?,or is it as easy as it looks by removing a couple bolts ? Will the rad need to be removed to make room?,or is it as easy as it looks by removing a couple bolts ? Will the rad need to be removed to make room?,or is it as easy as it looks by removing a couple bolts ?
How do you remove the head on a 1994 Camero engine?
by removing the head bolts
How do you change an axle seal?
There will need to be more information to properly answer your question. Some have 4 bolts holding the axle and some require removing the differential cover. Be more specific.
How do you change oil pan gasket on 2000 S-10?
You can change the oil pan gasket in your 2000 Chevrolet S 10 pickup truck by removing the oil pan bolts. Once the bolts are removed the oil pan will come off. Remove the old oil pan gasket and replace it with a new gasket.
How do you change starter 2002 gmc sierra 1500?
A person an change the starter on a 2002 GMC Sierra 1500 by disconnecting the battery and removing the retaining bolts on the starter. The original starter is then disconnected from the wiring and a new starter reconnected.
