How do you change front brake pads on a 2004 odyssey?

Answer 1

Front Brake Pad Removal and Replacement:

1. Loosen the front lug nuts slightly. Raise the front of the vehicle, and make sure it is securely supported. Remove the front wheels.

2. Remove the brake hose mounting bolt from the knuckle.

3. Hold the caliper pin with a wrench, being careful not to damage the pin boot. Remove the caliper bolt with another wrench.

4. Pivot the caliper up out of the way. Check the hoses and pin boots for damage and deterioration.

5. Remove the pad shims, pad retainers, and pads.

6. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.

7. Check the brake disc for damage and cracks.

8. Install the pad retainers.

9. Install the brake pads and pad shims correctly.

10.Install the pad with the wear indicator on the inside.

NOTE: Check the brake fluid level, the brake fluid may overflow the reservoir if too full.

11. Push in the piston so that the caliper will fit over the pads.

12. Pivot the caliper down into position. Hold the caliper pin with a wrench, being careful not to damage the pin boot. Install the caliper bolt with another wrench, and torque it to proper specification.

13. Install the brake hose onto the knuckle.

14. Press the brake pedal several times to make sure the brakes work, then test-drive.

NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several applications of

the brake pedal will restore the normal pedal stroke.

15. After installation, check for leaks at hose and line joints or connections, and retighten if necessary.