The whole headlight assembly comes out by pulling up on two tabs located on the back side of the plastic headlight housing. Once you have it loose, you can position it to get to the headlamp socket. Twist out the headlamp from the socket to access the bulb. Replacement bulbs are halogen, which you shouldn't touch with your fingers as oils from your hand are enough to crack the lamp, so it's a good idea to wear latex gloves or use a dry cloth when handling the new bulb.
The AC control head is the control panel for the heater/air conditioning in the vehicle.
on the cilynder head besides the engine
Olds intrigues have a habit of the heater/a.c. control head going bad. It will set you back about $600 to replace it.
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
HOW DO I CHANGE LIGHT BULBS
change a headlight on a 1997 plymoth voyager
To change the front head light you need to unscrew the screws to remove the protective casing. Once the protective casing has been removed the front head light bulb can be replaced with a new one.
how to change the rear tail light bulb on a 2004 Nissan maxima
To change the front head light you need to unscrew the screws to remove the protective casing. Once the protective casing has been removed the front head light bulb can be replaced with a new one.
I made a video on how to change the head lights in my jetta This is for a 2006 jetta tdi, but other years apply http://www.truezombielife.com/2006-jetta-head-light-replacement/
change the temp setting on the heater a/c control head
how do you change the head light time delay to 3 min. how to i get into the DIC information center, what steps do i take! (DIC)