on the cilynder head besides the engine
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.
The cast of Dual - 1999 includes: Markku Peltola as Mies
Had this issue with mine. It was the Crank Shaft Position sensor. The sensor is a dual sensor, so it will work until both parts fail, but it's dangerous, since this failure can really mess up the engine.
Most of the IAT sensors are part of the MAF sensor it is a dual sensor
No. There are more controlled mechanisms that the single control head cannot address. Without changing the air box as well, you can't swap the control head.
Where is the dual overhead cam located or the air temp charge sensor?
There isn't one. It only has a dual vane crankshaft position sensor.
House Hunters - 1999 Dual-Purpose House 14-1 was released on: USA: 1 July 2005
Location is behind the plastic air dam that forces air from underneath the car to go up and into the radiator (directly in front of a/c condensor). It's somewhat of a tight space, however you can pull it with force off the plastic air dam it's connected to (about midway down) and then unclip the sensor from the harness. Just don't pull too hard once you free it from the plastic air dam. These sensors rarely need replacing. If your Dual Digital Climate Control System is giving you an incorrect reading on the display for the outside air temperature, this indicates a couple of possibilities. 1.)The sensor tip is dirty and should be cleaned, or 2.)The green or white wire that goes to this sensor is worn or has broke somewhere before the sensor. This happened to mine (green wire broke) and would always give an incorrect outside air temp. I fixed the green wire and now the system functions correctly again. If you have to replace the sensor though, it should be part# 10248414 for a 2000 Intrigue.
Yes you can.
Yes it does, but they look plain and Jane.
56 oz of R134a