How do you change headlight bulbs in 2007 sierra without tiny hands?

Answer 1

I have replaced the headlight bulbs on my 07 Yukon, and after about an hour I finally found another bolt holding the headlight in. It is under the bottom of the headlight, and to get to it I took out two of the plastic clips holding the wheel well liner in place (the kind you release with a flathead screwdriver and twisting it after in the slot) then inside towards the front about an inch below where your headlight stops there should be a bolt that is extra long so you don't have to remove it all the way out, the light has a bracket with an open slot in it that slides behind the bolthead and washer. After holding your mouth just right you can get the headlight out and get to the bulb, a lot harder than the older bodystyle, which were set up with two pins that you pulled, took about two minutes. In my owners manual it says to take it to the dealer ??FOR HEADLIGHT BULB REPLACEMENT?? and probably a complimentary footlong hotdog, bread and condiments not included. Hope this helps it's a pain, but it's free.

2008 GMC Sierra same hassle unless you have a 10 yr old kid around and he was able to squeeze little hand in and replace bulb. Headlight bulb is common to replace, I give GMC design crew an "F"...