open hood go to the center latch dislodge the plastic cable retainer remove cable loop from the latch remove the two bolts from cable retainer left of the steering cable will drop thread it through the firewall from outside in reverse procedure.
To repair a hood latch cable on a 2003 Hyundai Elantra, you have to take it to your local mechanic or dealership. The hood latch cable should only be reconnected with an experienced hand. While you can use wrenches and screwdrivers, the latch cable may come loose again.
I believe the 2003 - and newer have the LATCH System. Check related link below... How the LATCH System Works on Car Seats
The latch assembly and cable is one piece.
To fix a hood latch on a 2003 VW Jetta that is stuck shut, the car should be put up on a hoist. A long pole will be needed to then trip the hood latch. Then the cable can be repaired and the car lowered.
The lift gate on a 2003 Dodge Durango can be opened from the inside if the latch is not working. There is a latch on the floor close to the door that can be tripped with the use of a screwdriver to open the gate. The cable for the gate might need to be repaired after this.
To replace the hood release cable on a 2003 Jaguar X-Type, start by removing the lower dashboard cover to access the cable's connection. Detach the old cable from the release lever and the latch mechanism under the hood. Install the new cable by securing it to the lever and latch, then test the operation before reassembling the dashboard cover. Ensure that the cable is routed properly to avoid any interference with other components.
Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)
You should only change it, when it goes bad.
Open the drivers door and on the latch pillar is an information sticker that shows the original size tire on the vehicle from the factory
To open a jammed hood on a 2003 Hyundai raise the vehicle's front end. Safely stabilize it and take a flashlight under the car to locate the latch. Use a flat head screwdriver to manipulate the latch and open it.
If the hood release cable is broken on a 2003 Mitsubishi Lancer, you can try accessing the hood latch directly. Use a flathead screwdriver or a similar tool to pry open the grille or the area around the latch mechanism, which is usually located near the center of the hood. Once you can see the latch, manually pull it to release the hood. If this doesn't work, you may need to consult a mechanic for further assistance.
the oil pump is in the oilpan but in order to change it you will have to to the timing as well