0
Do you mean the ignition key or the ignition switch? The ignition switch is located on the top of the steering column above the brake pedal. It's held on by 2 bolts. It's a lot easier to work on with the column removed. If you mean the ignition key. You need to remove the steering wheel, lock plate and turn signal switch. The key tumbler will either be held in by a screw or a tab on the tumbler. There are several sources on the internet with detailed procedures.
What else can I help you with?
How do you install a replacement ignition switch in a 1988 Jeep Comanche 4.0 V6?
To install a replacement ignition switch in a 1988 Jeep Comanche 4.0 V6, first disconnect the negative battery terminal to prevent electrical shorts. Remove the steering column covers and the retaining screws for the ignition switch. Disconnect the wiring harness from the old switch, then install the new ignition switch in the same position, reconnect the harness, and secure it with screws. Finally, reassemble the steering column covers and reconnect the battery.
1988 jeep wrangler runs while cranking quits when you let off?
you have an open circut in your ignition switch change your ignition switch.
How do you change ignition switch without key 96 jeep Cherokee was stolen and recovered?
Locksmith?
Where is the fuel pump inertia switch located on a 1991 Jeep Comanche?
there isn't one...
How do you reset the oil change indicator in a 2007 Jeep Wrangler x?
Switch the ignition ON - then pres the fuel pedal three times - then switch the ignition off .Thats all - miracle is done.
How do you change ignition switch on 1981 jeep wagoneer?
you must remove the steering wheel and turn signal from column. then you can acces the screw to remove the switch.
How to change ignition switch in 1985 Jeep CJ 7?
To change the ignition switch in a 1985 Jeep CJ-7, first disconnect the negative battery terminal to ensure safety. Remove the steering column trim by taking out the screws, then detach the ignition switch from the steering column by unfastening the retaining screws. Disconnect the wiring harness from the old switch and replace it with the new one, securing it in place. Finally, reassemble the trim, reconnect the battery, and test the ignition switch to ensure it functions correctly.
When was Jeep Comanche created?
Jeep Comanche was created in 1985.
How do you change ignition key switch 85 cj7?
To change the ignition key switch on a 1985 Jeep CJ7, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the ignition switch attached to the column. Disconnect the wiring harness from the switch, unscrew it, and replace it with the new switch. Reassemble the column cover, reconnect the battery, and test the new ignition switch to ensure it functions correctly.
What does an ignition switch do for a 1997 jeep?
It engages and disengages the lock that starts the vehicle. There are 2 parts to the switch. The ignition switch and the lock assembly.
99 Jeep Cherokee Laredo stay running after turn off the ignition switch?
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
What is the cheapest source of technical drawings of Jeep Comanche?
your fan switch might be bad look into replacing it
