it's simple you look for the oil pan and their is a bolt that is sticking out toward you. you then unscrew the bolt and let the oil drain out. then locate the oil filter and unscrew that. then you replace the filter with the new one and fill the engine with oil.
or take it to a repair shop/ dealer!
The automatic transmission oil temperature sensor on a 1992 Toyota Land Cruiser is in the engine compartment. it is near the inlet/outlet tubes.
10.7L (with oil filter change) LITER: GALLON: QUART:
take the car to the dealer. i think that would be the best bet. just to be on the safe side.
2.5l
A 1996 Land Cruiser take eight to nine quarts of oil. Use the oil dip stick in the engine to ensure the oil is not being overfilled and the proper amount of oil is used.
5qts
Where s the oil filter on a 2009 toyota landcruiser
The 2.4L uses 4.5 quarts.
9.3 ltrs including the oil filter.
This oil filter is for a Celica or a Land Cruiser Prado
Sounds like it was run too long with out an oil change.
Six quarts of oil are needed to change the oil on a 1992 Jeep Wrangler.