Drive it on to level ground and let it idle for 5 minutes. Switch off the engine and let it stand for 10 minutes. Then remove the drain plug at the bottom of the engine. Place some receptacle there before to catch the old oil. Let it drain for at least 20 minutes, then replace the oil plug. Pour in three quarts of new engine oil. Use the dipstick to measure the oil level at intervals. Don't overfill the engine with oil, some people have poured in 5 quarts and then gotten clutch slippage problems.
10W40
The Honda Rincon uses engine oil as transmission fluid so when you change your engine oil or check your engine oil level you are also changing or checking the transmission fluid at the same time.
after draining and filter change the Rincon takes 3.1 US quarts of oil. at disassemble the Rincon takes 4.3 quarts of oil. I have added a link in the related links section with more info from the service manual.
after draining and filter change the Rincon takes 3.1 US quarts of oil. at disassemble the Rincon takes 4.3 quarts of oil. I have added a link in the related links section with more info from the service manual
after draining and filter change the Rincon takes 3.1 US quarts of oil. at disassemble the Rincon takes 4.3 quarts of oil. I have added a link in the related links section with more info from the service manual
inside the front engine casing.its very time consuming to get to but its the oil pump sprocket that actually come lose and pops the chain off
until its full
1.6 l at oil filter change
To reset the oil change light, hold down the odometer and clock buttons for a few seconds. (with the ignition turned on).
what type of oil sould i use in a 650 cx custom motorcycle
How much engine oil does a 1982 Honda Nighthawk 650 take? 3.4 quarts
Its on the Right side just behind front fender, its roundish