0
o my
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the Oil Pressure Switch on a 92 Ford Probe?
The oil pressure switch should be above the oil filter on the back of the engine on a 2.2L.
How do you change the axle in a 1985 ford probe?
THERE WAS NO FORD PROBE IN MODEL YEAR 1985
Where is the inertia switch on a 94 Ford Probe?
in the trunk. under the carpet, in the leftside quarterpanel
How do you find the fuel cut iff switch on a 1997 ford probe car?
find fuel cut off switch
How do you find and change the thermostat on a 1997 Ford Probe GT?
try this link it may help keep in mind ford probe's have Mazda engine's
How can you by pass an inertia switch on 1993 Ford Probe?
If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this. If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this.
Is it hard to change an AC low pressure cut off switch on a 1997 Ford Explorer?
no . unscrew and screw back on
How do you change a power steering pressure switch on a 2000 ford focus?
unscrew the old one, then screw the new one in..?
Where is the oil pressure switch on a 1998 Ford F-150 4.2L engine?
Where is the oil pressure switch on a Ford F-150 4.2L engine?
Where is the inertia switch on 1993 Ford Probe?
hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.
Why does Ford Probe ignition stays on even when key is not in ignition?
Defective ignition switch or tumbler assembly.
How do you change out a Ford Probe Transmission?
take out the old on and put in the new one
