0
remove the trim around switch, remove screws that hold switch in, pull switch out, remove wire connector.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you install a Hazard light swithch in a 2000 Malibu?
remove trim plate around switch,take out screws holding switch in,remove wires then replace in reverse order!!
2000 Malibu flasher location?
the flasher and hazards are all in one . if flashers are bad check hazard switch on dash. remove trim plate and remove screw that holds flasher switch in.
Where is the fuel pump reset switch on a 2000 Chevy Malibu?
no reset
Where is the wiper relay in a 2000 Chevy Malibu?
The 2000 Chevrolet Malibu windshield wiper relay switch is located on the firewall in the engine compartment. The windshield wiper relay switch will be on the drivers side of the firewall.
Where is the ac clutch cycling pressure switch located on a 2000 Chevrolet Malibu?
It is on the acumulator.
Where is the thermo switch located 2000 Chevy malibo?
where is the gas fuse located in a malibu
What size socket fits the front hub nut on 2005 Malibu?
how do you replace front passenger window switch on a 2000 chev malibu
What does it mean when the sound of the blinker goes off but you did not turn on the blinker?
Depends on the year. I know that the 2000 Malibu was recalled for the hazard switch going bad. Check the recall to see if your car is covered, the take it to the dealer to get it fixed. Good Luck
Where is the turn signal flasher for a 2000 Pontiac Grand Am GT?
On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.
Air condition switch location 2000 Malibu?
it is on heater control on right bottom, fan has to be on for it to work.
How do you change the harmonic balancer on 2000 Malibu 3.1?
what do you need to take off car to get to c/shaft pulley on 2001 malibu
Can you put a 2003 Chevrolet Malibu computer in a 2000 Chevrolet Malibu?
I doubt it very much as they change engine specs every year.
