remove trim plate around switch,take out screws holding switch in,remove wires then replace in reverse order!!
You're going to have to change the hazard light button on the dash
Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.
where do you find the replacement bulb for a 2001 Chevy Malibu ls for fog light replace ment on the car
screwed into the transmission.
you need to replace the hazard light switch the turn signal control module is built in the hazard switch.just had same problem a few months ago.
If you turn/hazard lights don't work, or work when they want to, even if its just the turn signals or just the hazard likes that stop working, it gonna be the relay/flasher unit. It's located under your hazard light button. Your hazard light button sits on top of the unit. So if you have a persiting problem or an intermitant problem it's gonna be that unit. You can take off the portion of you dash that contains your vents, hazard light button and light dimmer poteniometer simply my just carefull prying it out srom its clips, be carefull when pulling it out as not to brake any of the plastic.
Remove the light bulb connector from the light. Take hold of the light bulb, push in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
pull the light swithch once for front twice for rear that puts both on
signal light
the hazard light flasher relay is bad
Pull the hazard light fuse.
you tell me how to change head light bulb on 2009 chevy malibu.