There are 2 large 7/16ths screws (both colored black), both on the top of the headlight assembly. Remove both of them, then pull the assembly out towards the front of the car. You might have to pull out on the bottom of the assembly first to remove it. Once the assembly is removed, look at the back of it...The Low beam bulb is the one closest to the yellow signal bulb. The other one, furthest away from the signal bulb is the high beam. Remove the wire clip from the bulb you want to change (you might have to use a small screwdriver to release the plastic catch). Once the wiring is removed, turn the light socket counterclockwise (looking at the back of the assembly) to remove the bulb from the assembly. Just reverse the procedure to put the new bulb into the assembly. When done, put the assembly back in place and replace the two long screws.
Open Hood. Open the hood of your Mazda 5. The hood release is located under the dashboard of your 5.
1) Open front hood. 2) Twist lowbeam connector from back of headlight casing. 3) Twist apart bulb from the connector. 4) Replace with new bulb. 5) Reverse order of above steps to finish.
Passenger side in the transmission bellhousing. Pain to get at!
The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?
Not positive about the 2000, but in my 1999 they had to take off the front passenger tire to change the battery.
replace passenger side low beam headlight
Unlike other cars, the Intrepid requires you to remove the entire headlight housing. This is very simple, there are to long bolts on top of the housing that hold the housing on. Simply remove these bolts, untwist the bulb, replace the bulb.
Because it is burnt out. Change the bulb.
To change the passenger headlight on a Renault Clio, one should open the compartment and remove the rubber seal from the back. From there, the bulb holder should be removed by twisting, then a new bulb should be inserted into the holder.
Open the hood to the engine compartment. Take hold of the headlight connector. Push the connector in and turn at the same time. The lightbulb will come out. Reverse the process to install the new lightbulb.
Remove the complete dashboard. This is NOT an easy thing to do! It is back there in the center behind the radio and passenger airbag.