Raise the liftgate. You'll need a 7 mm socket or nut driver. The brake/blinker light is a #3157. There are two hex-head screws to remove. Pull the tail light straight back off the car. There are two little metal prongs that need to release from their rubber grommets for it to pop off. I needed to use two flat head screw drivers to help me get the light to pop off, but if you have strong fingers, maybe you won't need them. Replace the bulb by pushing in the mechanism on the socket, and turning about a 1/4 turn. Pull the socket out, and then remove the bulb by gently pulling it straight out. Don't twist. Put everything back in reverse order, and PRESTO! And you didn't even have to ask your husband to help you ! ;)
front or rear?
u dont
Remove the tail light cover in the cargo compartment. Remove the wiring harness. Remove the blinker retaining screws. Reverse the process to install the new blinker.
i have an 03 aztek. i change plugs myself, i have skinny arms to reach from underneath the car.
How do I change rear breaks on a 2003 tracker 6cyl 4x4? the axle is in the way...
how to change broken spring on a 2003 buick renezvous left rear
Just change the fluid, it should be right next to the oil dipstick under the hood
Check the ground, without a proper ground it will not light up
The rear ti light lense is held in by two screws. Lower tailgate, remove screws, grab and pull taillight rearward.
Sounds like a bad earth connection around the rear light cluster.
Answer : unscrew the signal lens and remove the signal bulb and replace with 1157 bulb reverse process
Jack up vehicle and change the rear plugs from underneath!