In the back, directly behind the lights, the trim must be removed.(
There will be some clips or screws holding the carpet or plastic in place). once removed you will see the back of the lights, then its just a case of removing the blown bulb and replace a new one and fitting back the trim......
Brake light switches are above the brake pedal
most times if brake lights are stuck on you have a bad brake light switch on pedal under dash
my brake lights are not working on my ford mondeo. i have replaced both bulbs and they still do not work.i am wondering if the fuse has blown , but i cannot locate it. can you help please?
remove the break light by undoing to plastic nuts located on the back of break light, you must remove two covers to get at the nuts unscrew them and the unit will pull out. put new bulb in and put nuts back on tighten them back up making sure the unit is square and the job is done
what do you have to do to change the center brake light
WHICH brake light?
Less than 20 mpg urban , and i have a light foot ....2l auto estate
if it is new shape mondeo turn on ignition press brake pedal and clutch at same time hold fully down for 30 seconds service light should then reset
how to change a brake light on 2002 Nissan altima
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.
it might be the sensor or the brake bars are worn out if there is abs on the car and it is also on you could try cleaning all sensors with wd-40 or high quality brake cleaners