Pop the trunk, remove the "3 wingnuts" behind or on the carpet. That will in turn loosen the tail lights. Turn the bulb, and voila!
Check bulbs--they are dual filament smaller is for brake and turn signal --larger is for tail lights
you cant you cant
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
No, they will not work, the Intrepid uses a 9007 (hi & low beam in one bulb), the Avenger uses a 9005 & 9006 (separate bulbs for hi & low beam), therefore neither the headlight housing nor the headlight bulbs will interchange.
You must first remove the Trunk liner back far enough to get to the light cavity. There are two bulbs that make up the center third brake light. Just twist the light out of the lock position and replace the bulbs with appropiate replacements and then screw back in.
pull down on both sides there is a clip on both lf and rt side I did this a week ago to change my bulbs, yes no one could answer this for me also.
Both bulbs are out, wiring problem, switch problem, fuse, relay.
I would guess that both of your brake light bulbs are burned out, and only the high mount bulbs are still working.
faulty brake light switch (on pedal)
Check the fuse, check the bulbs, check the brake light switch, in that order.
#1157.
To fix a 95 Dodge Dakota with no brake lights, first check to ensure the fuse has not blown. If the fuse is good, check to ensure the brake light bulbs are not burn out.