0
there should be a drain bolt on the lower front or rear section and a bolt on the top remove the top bolt and put the drain bolt on the bottom back in and fill the case from the top bolt untill fluid runs out and screw top bolt back in and hit the road
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change an oil pump in a 1989 ford ranger?
Remove oil pan
Change oil pan 1992 Ford Ranger?
Yes
Where is the oil drain plug on a 2000 Ford Ranger 2.5 4 cylinder?
The oil drain plug on the 2000 Ford Ranger is on the rear of the oil pan. It is located under the vehicle near the center.
What type of gear oil goes in the rear end of a 1994 Ford Ranger rear end when replacing the rear seal?
Any brand of WD40 oil will work.
What do you put into the rear pumpkin on a 2003 ford ranger?
gear oil if it has posie put in the adtivive
What type of gear oil does a 1993 ford ranger take in the rear axle?
The 1993 ford ranger uses 80w 90 gear oil in the rear differential. While some people use other mixes for special applications, this is the factory recommended oil for everyday use.
Do you have to pull the engine to change the oil pump on a 1999 ford ranger?
Have to drop oil pan
What kind of fluid transmission for a Ford Ranger 1998?
I am trying to change the oil transmission on my ford ranger 1998 but I do not know what kind of oil it needs. it's a 4 cylender
What is the correct number of liters of oil for an oil change on a 2003 Ford Ranger with 3liter v6?
According to the 2003 Ford Ranger Owner Guide : For the 3.0 litre V6 engine : With engine oil filter change ( 4.3 litres of engine oil )
How do you change the rear main seal on a 1990 ford ranger?
pull the bell houseing bolts out jack the motor away from the A frame then unbolt the oil pane then your at the seal
What is the oil capacity of a 3.0 Ford Ranger?
4.5 quarts with filter change.
What weight of oil is used in a 78 ford f100 ranger?
80-90w in the tranny and the rear differential.
