0
You have to take the oil pan off, then the oil pump, then the rear main cap. They make a tool called a chinease finger to get the upper half out, and the new one in around the crankshaft.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Is the rear of a small block Chevy bell housing the same bolt pattern as a 235?
No.
How do I replace the Rear main engine seal on a small block Chevy?
You will need to remove the transmission.
How are the cylinders numbered on a small block Chevy?
Drivers side, front to rear, 1,3,5,7. Pass side front to rear, 2,4,6,8.
How are cylinders are numbered small block Chevy?
Drivers side, front to rear, 1,3,5,7. Pass side, front to rear, 2,4,6,8.
How do you replace the rear main seal on a Chevy v6 small block?
Need to know the year of engine.
Where is the oil sending unit on 1984 Chevy small block?
It's usually on the rear rail under the distributor.
Where is 1 on small block Chevy?
Drivers side front, followed by 3,5,7. Pass side front to rear 2,4,6,8.
Where is number 1 cylinder on a small block Chevy?
Drivers side, front to rear, 1,3,5,7. Pass side, front to rear, 2,4,6,8. Firing order 1,8,4,3,6,5,7,2.
Does Chevy small block engine 350 57lg sgi does it have one piece or two piece rear main seal?
2
How do you change a crank position sensor on a 2002 Chevy 8.1L?
It is at the left rear of the block. Have not changed mine yet so not sure what it will take.
How do you change the rear brake pads on a Chevy Malibu maxx?
How do you change the rear brake pads on a 2010 Chevy Malibu
How has the Chevy 350 block changed in any way other than bore?
The Chevy small block went from a 2 piece rear main seal to a 1 piece rear main seal in 1987.
