0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is a vertical shaft engine?
Drive shaft is vertical- like a lawnmower. Cylinder is horizontal.
How do you change a Fiat Doblo drive shaft?
how to remove a drive shaft on a fiat doblo
Do you know what equipment is required to control the speed of motor shaft rotation angle of motor shaft and reverse the direction of motor shaft?
Variable Frequency Drive
Do you have to change the drive shaft when you replace the drive shaft oil seal on a 2006 Nissan navara?
No you do not.
What does overdrive mean?
There are two shafts in a transmission - an input shaft and an output shaft. The drive ratio is determined by the number of full turns the input shaft makes for each full turn of the output shaft. For example, if it took 1.5 turns of the input shaft for the output shaft to make a full rotation, you'd have a 1.5:1 ratio - this is known as underdrive, or gear reduction. If the input shaft made one complete rotation for each rotation of the output shaft, you would have a 1:1 ratio - this is known as direct drive. When the input shaft makes less than a full rotation for each full rotation of the output shaft, that's overdrive. For example, the fourth (overdrive) gear in a 4L60E transmission has a .70 overdrive ratio (i.e., .7:1), so it would make 7/10th of a complete rotation for each full rotation of the output shaft.
In a 4.11 ratio rear end is that 4.11 turns of drive shaft for one wheel rotation?
Yes.
Where is front abs sensor peugeot 406 2000?
ring on drive shaft with senser next to it. usual fault! cracked by rust ring on drive shaft. change shaft.
Can you use short shaft transmission in a Chevy truck turbo 2 wheel drive pickup in place of long shaft transmission?
You can but you will have to change or alter the drive shaft also.
How do you change a drive shaft on citroen synergie?
Take it to a garage,,,
How do you change drive shaft on neon?
go to a repair shop
How do you change u-joints on a 2003 dodge 3500?
there are 4 bolts on the upper drive shaft where it connects to the transmission and 4 bolts on the lower part of the drive shaft where it connects to the differential the drive shaft must be dropped to change a u joint and bolt back up the way it came off
How do you change a 3.9L to a 318 in a Dodge d150?
Eng,trans,drive shaft
