remove the center cover on the engine,two cross head screws this will give you access to the leads and plugs
,
Mine does
in the rocker cover
put a spark plug on the end of a spark plug lead and earth the side of it to a bit of metal in the engine..get some one to wind it up and if it doesn't spark, the coils not working. use insulated pliers when you hold the lead!!
something around 110Nm
there is none it,s a hyrdaulic system
As of my last update in October 2023, specific data on the number of Rover 414 saloons currently on the road may not be readily available. The Rover 414, a model produced in the 1990s and early 2000s, is considered a classic and has likely seen a decline in numbers over the years. For the most accurate and up-to-date figures, you may want to check with vehicle registration databases or classic car registries.
10W-40 (per the haynes manual)
On a Rover 414, the thermostat is typically located near the engine, often on the engine block or in the coolant housing. It's usually situated along the upper radiator hose, which connects the radiator to the engine. For precise location and access, it's advisable to refer to the vehicle's service manual, as configurations can vary.
You add it to your water tank this is used to stop oil leaks in engines, follow instructions to the letter or it will not work.
200
To disable the alarm on a Rover 414, insert the key into the ignition and turn it to the "On" position without starting the engine. Then, press the alarm button on the remote or use the key fob to unlock the doors, which should deactivate the alarm. If the alarm persists, disconnect the car battery for a few minutes and reconnect it, which may reset the system. Always refer to the vehicle's manual for specific instructions related to your model.