Disconnect battery positive, jack up pass side so you can get under car, follow pos batt cable to end to locate, Remove pos cable and wires from solenoid, noting their location, Should be held in place with 2-3 long bolts into block. Be very careful to support starter when you remove the last one-they weigh almost 50 lbs-or the same as your battery. Be sure problem is not the charging system before you proceed. many replace starters needlessly when problem is elsewhere. they take almost 10 volts to crank, so that is where a battery problem first becomes evident.
NO /UNLESS YOU GET THE HARNNES (FOR THE 98' ) STARTER.AND THE LENGHT IT'S LONGER ON THE 98
How to change a starter on a 1998 montero sport
The starter on a 98 Ford Contour SE is changed by disconnecting the battery, jacking the vehicle up, and removing the starter shield. The retaining bolts and bracket can then be removed, the wires disconnected, and the starter removed.
A 1998 Chrysler Town and Country has a timing chain which does not have a service interval.
Disconnect the - battery cable Raise and support vehicle Remove starter mounting bolts Disconnect wiring harness at top of starter Remove starter
do you have the schematics for a '98 softail starter?? do you have the schematics for a '98 softail starter??
98 Toyota Camry Starter Installation
i need diagram for a starter a 98 ford contour
On a 98 venture the starter is located in front and just under radiator. Simple to reach and change. I learned the hard way.
does anyone know where a starter is located on a 98 acura 3.5 RL
The solenoid is on the starter.
replace your mapp sensor