The easiest way to change them is on a hoist. if you dont have acess to one jack up the front of the car and put stands under it.disconnect the batterythere will be two bolts going through the starter into the bellhousing, remove the two bolts. they should be 13mmonce you remove the starter remove the wires attached to the solenoid making sure to take note of where the wires go.it is easier to remove the wires once the starter is out as you will have more room.when you put the new starter in put the wires on firstfit the starter then reconnect the batteryRead more: http://www.justanswer.com/questions/1woj2-change-starter-motor-ford-falcon#ixzz0TUgd4eNV
Ford EF Falcon was created in 1994.
how to remove inhibitor switch on ef falcon
no
If your looking at the engine front on, it is the top right but right underneath. The only way to get at it from underneath the car. Found out the hard way it is very difficult to remove and replace due to the position of the bolts, very hard to get to.
Through the dipstick Through the dipstick
Use your hax to do it
NO they changed after EF AU an BA are they same
don't
Where you least expect it.
most likely under your overflow tank behind your battery.. it is a grey relay with a yellow and purple wires coming off the side on another relay
yes