You can access the tail light assembly from the cargo compartment. Remove the tail light wiring connector. Push in and turn the lightbulb, at the same time, to remove it. Reverse the process to install your new tail lightbulb.
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.
Not sure on the 89 Geo Tracker but on most newer vehicles the tail light bulbs can be accessed by openening the rear door and removing a panel that allows access to the tail lights if this is not possible you should have some type of screws on the tail light lenses itself that can be removed to access the bulbs. , EzForJesus my 91 Tracker 2 door had 2 small screws at the bottom of the tail light - I had to push the rubber fascia down slightly to get a Phillips screwdriver into the screws. Remove both screws, tip the bottom of the fixture out and you now have access to the 1/4-turn twist-out bulb holders. Change bulb(s) and reverse procedure. Cass1959
93 tracker
hjfdjdfjgjdf
remove the felt lining in the trunk. this will allow you access to the bulbs.
To change the voltage regulator on a 94 Geo Tracker, locate it in the black plastic box on the back of the alternator. Unplug each cable from the regulator, remove it and replace.
i have 1995 4x4 geo tracker with a bad auto transmission will a auto transmission out 1998 4x4 geo tracker fit in 1995
does 1990 geo tracker have air bags
In almost every case of this occurrence, this is your tracker telling you it needs a transmission overhaul.
An auto parts store can reset it for you.
(1995) ( Geo) ( tracker ),the wheel light comes on with the hubs locked in and the shifter in , but the 4 wheel drive does not appear to be locking in.
How do you add refridgerant to a 1997 Geo Tracker?