remove the felt lining in the trunk. this will allow you access to the bulbs.
The # is 1157 bulbs.
What is the part number for the 2008 HHR tail light bulbs and backup light bulbs?
You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.
Well If you unscrew the taillight from the car take it off you can change you tail light bulbs
To remove the tail light bulbs from a 1994 Pontiac Trans Am, first, open the trunk and locate the tail light assembly. Remove any screws or bolts securing the assembly, then carefully pull the assembly out from the body of the car. Twist the bulb socket counterclockwise to release it from the assembly, and then pull the bulb straight out to replace it. Reassemble the tail light by reversing the steps.
open your trunk to get access to your tail light, unscrew some plastic snap-on-screws to get to the panel that holds all your tail lights move the fabric uncling the panel CAREFULLY and change your burn bulbs
Replace the whole light assembly Their are no bulbs it is neon light
To change the tail light bulbs on a 2007 Suzuki Forenza, start by opening the trunk and locating the tail light assembly. Remove the screws or clips securing the tail light assembly to the vehicle, then carefully pull the assembly out. Disconnect the wiring harness and twist the bulb socket counterclockwise to remove the old bulb. Replace it with a new bulb, reassemble the tail light assembly, and secure it back in place.
To change your Durango's tail light, first make sure to have a flat head screw driver and a new bulb. You will then open your trunk and remove the screws to the tail light, swap out the bulbs and replace the housing case.
Remove the bolts !
Burnt fuse...the tail lights and dash lights run together. Replace the fuse and if it burns again, change tail light bulbs first (some may be bad even though they work) and then look for bad wiring if the bulbs haven't fixed it.
Remove the light assy then turn the bulbs countereclockwise to remove the bulbs.