answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2007-06-01 13:56:01

See the "online shop manual" at "www.mx-3.com" under "Technical". It's fairly standard with the usual Mazda quirks regarding tools, if you've done these before you'll probably manage it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

How do you change the thermostat on a 1993 Mazda mx3?

waste of time


In What Order Do You Put Spark Plug Wires on a 1993 Mazda mx3 4 cylinder?

1234


How do change brake pads on Mazda mx3?

well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads


Where is the inertia switch on a 1993 Mazda MX3 4 cylinder?

The 1993 Mazda the inertia?æswitch can be found on the firewall in the engine compartment. The inertia switch will be on the passenger side of the firewall.


Where is the IAC Valve on a 1993 Mazda MX3?

The idle air control valve is on the the bottom of the throttle body.


Where can you find rear brake parts diagram for Mazda 1993 mx3?

I haven't been able to find.


Where is the inertia switch on a 1993 Mazda mx3?

A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.


Where is the fuel pressure regulator in a 1993 Mazda mx3?

The fuel pressure regulator is located on the fuel rail of the vehicle.


Where is the fuel pump relay for the 1993 Mazda MX3 1.8L K8 v6?

in engine bay fuse board


Why does my 1993 Mazda mx3 idle rough when the brake pedal is depressed?

ckeck for vac. leak at brake booster


Can a ignition control module cause my 1993 Mazda mx3 to run rough like its misfiring or what electrical component can cause it to run rough like its misfiring?

What causes my Mazda mx3 to turn off while driving down the road.


Head gasket bolt torque specs for a Mazda mx3?

What are the head bolt torque specs for a mazda mx3 1600


What do you do when the automatic seat bealt is stuck and will not move on a Mazda mx3 1993?

Mazda has a recall on their seatbelts for some models for this reason. ask a Mazda dealer if your model has the seatbelt recall. I believe the 92 mx3 has a recall for the auto seatbelts, but i am not sure about 93. Look into it though and they might fix it for free!


When was the Mazda MX3 first produced?

The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.


Mazda mx3 1993 wont shift out of park?

The neutral safety switch, release switch, or brake switch is bad.


Where is the starter on 1993 Mazda mx3?

Under the intake manifold. The starter is connected to the bell housing on the transmission and is held on by three bolts.


Will a 1994 Mazda mx3 dash fit in a 1992 Mazda mx3?

yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.


Why does your 1995 Mazda mx3 fuel burp apon axcel?

Change your spark plugs. Bosch super plus.


Where do you add transmission fluid to a 1993 Mazda mx3 manual 5 speed?

if it is a 5speed it does not take trannsimission fluid it take cluth fluid


What is the most likely cause of coolant leaking from right rear of engine near firewall in 1993 Mazda mx3?

heater core leaking


The rpms on a Mazda mx3 1994 mine is set to high how can you get it lower?

don't accelerate as much or change up a gear


When wraming up why does a 1993 Mazda MX3 V6 rpm's jump up and down?

because is reeving, there for it depends on the amount of pressure you apply to the gas


How do you set timing on a 1995 Mazda MX3?

This is done the same as the 1995 Mazda MX6. The answer is posted.


How do you fix a blown head gasket in a 1993 Mazda mx3?

You pull the head off and change the head gasket. There is no treatment for a blow gasket, exept changing it. Its a pretty huge job I would suggest getting it at the garage and get a quote.


Is 1993 Mazda mx6 interchangeable with 1995 Mazda mx6?

most parts are yes. most parts are also interchangeable for ford probes of the same year range (excluding body parts of course --- Many interchangeable parts on 1993 Mazda Mx6: 1993-1996 Mazda 626 1993-1996 Ford Probe some parts off the Mazda MX3 some parts off the 1998-2003 Mazda Protege some parts with 1996 are not compatible due to OBDII legislature, which changed emissions and other changes.