Hyundai Elantra
Lincoln Navigator
Air Pollution

How do you change the air filter in your 1997 Hyundai Elantra?

555657

Top Answer
User Avatar
Wiki User
Answered
2005-09-09 16:09:36
2005-09-09 16:09:36

Take the old one out and put a new one in.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


1997-2000 Hyundai tiburon, 1997-2000 elantra.

The firing order on a 1997 Elantra is 1,3,4,2

1997 Hyundai Elantra Battery Size: L4/1.8 battery (12V)

no it won't the 2000 has diffrent plugs by the dip stick its a six pin . i made that mistake and got a 99 at trans for my 2000 and notice its the same in a accent 97-99 and the elantra but change in 2000 hope this helps

The Hyundai beta motor has not seen much change in 13 or so years it has been around the starters should be interchangeable.

I've yet to change mine, but I hear that you specifically need to get Hyundai brand tranny fluid. Don't use generic.

Instructions with pictures can be found here:http://www.rdtiburon.com/index.php?showtopic=30576&hl=alternator

Yes. 1996 through 2000 Elantras and 1997-2001 Tiburons are basically all the same car, with different skins.Stocker @ RDTiburon.comDavid @ votefordavid.blogspot.com

I'm not sure but they're usually located in the center

Under the driver's side dash on the left. Look for the little door.

for a 98 it was $50, plus tax, straight from the dealer

How do you change a fuel filter in a 1997 Honda Prelude

Does not have one. The engine uses cam overlap to achieve the effect of the EGR valve.

Unfortunately it usually requires removal of the entire gauge cluster. I've never worked on your type of car before though, so I could be wrong.

Photographs and an explanation can be found here:http://www.rdtiburon.com/index.php?showtopic=29801

CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Relieve the fuel system pressure * Disconnect the negative battery cable * If necessary remove the air cleaner assembly * Remove the clips and detach the hoses from the fuel filter then remove the filter bracket nuts and lift the assembly out of the engine compartment

Take it to the dealer... :) Seriously. I had a 1998 elantra, and I believe up until 1999 they used what are called "captive" rotors. Basically meaning you have to disassemble the hub in order to remove the rotor. It's a royal PITA and I would highly recommend it not be attempted without thorough instructions.

The oil filter is on the side of the engine closest to the front of the car. there is a hole on the front skid plate to reach the filter through.

The IAT sensor on a 1997 Hyundai Accent is found in the piping for the intake system. The sensor will be plugged and mounted near the air box for the air filter.

it could be biulding up to much back pressure though the return for the fuel you should have some one take a look but it should be fine


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.