You can access the backup light on your Pontiac from the trunk compartment. Remove the backup light cover. Take hold of the backup light connector, push in and turn at the same time. Do the same with the backup lightbulb. Reverse the process to install the new lightbulb.
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
how do you replace backup lights on 99 grand am?
headlights and dash lights in 2001 sunfire wont turn on.
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
is the trac align light mean
u have a blown headlight. change both bulobs and it will stop.
i have three on mine two tail lights and one under the spoiler
yes thay do have DTR on a 1995 sunfire
Check the bulbs, check the fuse then check the switch.
I have a 1995 Pontiac Sunfire . The "check gages " light comes on when my gas tank is on empty. I dont know if this is a right answer but this is how I know I need to fill up at the gasbar .
You have to remove the tail light lens cover from inside the trunk- there are about 6 nuts holding it on --the whole cover comes off and bingo there are your lites for the Pontiac emblem that lights up!! There are no lights persay just for the Licence plates on my 96 Sunfire and I assume the same on a 98
On my 98 sunfire, the tail lights and marker lights only work if you turn on the headlights. If only the daytime lights are on, the Pontiac on the trunk is illuminated but no other lights at the rear until brakes or turn signals are activated. This is common with a lot of vehicles out there. Daytime running lights are not necessarily the same candle power as the headlights. I can tell a big difference in mine.
Dash ground is loose.
you need to change the flasher can for the signal lights
Answer location of check gauges lightthe check gauges light is on your instrument panel when it comes on it lights up saying check gauges
It is one big peice that must be removed. If you open the trunk, look on the inside of the lid behind the license plate, and you will find a few nuts that once removed, will allow you to remove the entire rear facia panel that the license plate bolts to and which houses the "PONTIAC" lights.
yes you can
Hello, all you have to do is turn the back of the light post and pill the lights out for both the fog lamps and the break lights. For the break lights, its less work to change.
Main ground for dash is loose.
You might be able to get one through a dealership, but I'll bet they're danged expensive. I'd check with local junkyards.
Did you recently change or install something in your car like a stereo or GPS?
if you pull up ever so slightly on the e-brake the lights wil go out. carefull not to engage the brake while moving. but just lifting it a little will engage a sensor that turns out the lights.
Dashboard lights are used to help the driver know what is going on with the vehicle. The cars manual will have a diagram specifically for the vehicle's year, most have a oil change, gas, check engine, battery, and seat belt dash light.
It doesn't have any. The only C2 (1963-1967) with backup lights is the '67.
Probably the wrong bulbs or the brake lights are getting stuck "on". Or maybe a combination of the two. Check that you have the right bulbs and check to make sure something isn't keeping the brake lights on. FriPilot