The built in garage door buttons run off of the cars battery.
check out this link http://www.homelink.com/home/home.tml
Press and hold the button you want to use for that door and hold the button on the gargage door opener at the same time for 30 sec
Opener - album - was created on 2005-05-31.
It's located in trunk
Owners manual or call Jeep. Beter Answer: Go to this site. http://www.homelink.com/training/train.taf I was able to program mine with a bit of reading. Also check your maunal of your garage door opener. There are extra steps if it is like a Geinie with rolling codes. If the above link does not work. Try using the following link http://www.eurohomelink.com/PDF-Download/manuals/GB_HomeLink_General_Bedienungsanleitung.pdf I was able to program 2011 sienna XLE garage door opener whose controls are on the rear view mirror.
steps to set the remote control buttons on ES330: 1) close your garage door, set the opener in lock status, 2) push the button of a existed remote control for your garage opener, at the same time push a selected button of the remote controller on your ES330, keep pushing the both buttons for over 15 seconds until there is quick flash happened in your ES330 car's remote controller, 3) push the leaning button in your garage opener once, then a leaning light will flash on the opener, 4) then immediatelly push the selected button of the remote controller on your ES330 once, then push the button again, if the door did not open at this time, you should push the button again. 5) now the you finished the setting on the remote button in your ES330.
The battery on a 2005 Pontiac Montana is changed by raising the hood, loosening both of the battery cables, and lifting them off the posts. The old battery can then be lifted out, a new battery put in, and the cables reattached.
Think Garage was created in 2005.
use a 10mm wrench and remove the battery from the trunk compartment, and replace it with the new battery
what model? 2005 HD Road King Custom
Volkswagen Key Disassembly
To change the battery in a Ford (2005) F150 pickup truck - one needs to open the hood and identify where the battery is. It should be on the passenger side, right next to the chassi. You need to disconnect the positive and negative leads and unscrew the bolts holding the battery. You then can replace the battery using the same setup.