0
take the negative batter cable off, then the positive cable off, undo batter hold down clamp, take battery out. put new battery in, install batter hold down, install positive cable, then install negative cable. (in that order)
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where do you change the oil in a 2003 GMC sonoma ZR2?
In your garage or driveway!
How do you change the blinker lights on the front of a GMC Sonoma?
Take the whole lens out
Do 95 GMC Sonoma have timing belt?
No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.
What year did General Motors come out with the gmc sonoma?
The GMC S-15 became the GMC Sonoma in 1991.
How do you change fuel vapor sensor on a 1997 gmc sonoma?
To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.
How do you replace a starter on a 1998 GMC Sonoma?
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
GMC sonoma will not turn over?
Check your battery, neutral/park switch, brake switch (if part of immobilizer).
How do you change the Cabin Air Filter on a 2002 GMC Sonoma?
Are you sure your vehicle has one?
Where the timing connector on 95 gmc sonoma 2wd?
Where is the timing connector on a 1995 gmc sonoma
What is bolt pattern for 1994 2.2 GM Sonoma?
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4
How do you reset service engine light 2002 GMC Sonoma?
get your hands on a code reader or disconnect your battery for a few minutes
Where is the crank position sensor located on a 1997 gmc sonoma 2.2?
were is csp on gmc sonoma 2.2
