0
Look inside the trunk. On both sides, near eac corner are access hatches for getting to the brake, directional and back-up lamp assembly. Raise up the trunk liner flap and you will see the back side of a white plastic assembly panel that holds the bulb sockets. Locate the small bronze colored Phillips screw. Back it out several turns and stop because it only will move but so far before it just keeps spinning. Then locate the two squeeze clips located on the white assembly and squeeze them to dislodge the assembly. Remove it carefully or else you will fracture the bulbs as you pull outward. The bulbs come out with a downward push and a twist.
The removal process will be easier if you first disconnect the grey plastic wire harness plug that supplies power to the assembly, but it idoes not have to be done. Look for a pressure clip to push in before pulling the grey plug out.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where can I get a wiring diagram for 1993 Acura Vigor?
you'll find the whole shop manual for the Acura Vigor for free at www.spoonertuner.com/manuals
Why do the brake lights on 1993 Acura Vigor stays on?
There is a switch that is activated by the arm of the brake pedal. You can see it by looking underneath the dashboard. The switch could be malfunctioning or it may have to be adjusted by loosening the locknut and backing it away from the the brake pedal arm.
What is the oil capacity of a 1993 Acura Vigor?
4.5 quarts if you are also replacing the oil filter.
1993 Acura Vigor what is code 4?
code 4 is your Crank shaft postion sensor
Locating the fuse panel for the 1993 vigor?
On my 1993 Acura Vigor it is all the way in the back on the bottom on the left side undernieth the driver's side. Grab a flash light and you should be able to find it.
Where is the ecu on the 1993 Acura vigor?
under the passenger seat pull the carpet up u will see the ecu cover you will have to take the 4 nut off then unplug the ecu and pull it out and change.
How much is a distributor cap for a Acura Vigor 1993?
Depending on where you are located...eg. Canada or the States and brand, anywhere from $10.00 to $50.00.
My hand brake light on my 1993 acura integre RS doesnt turn off any ideas?
that means your brake fluid is low
Why is brake lamp on 1993 Acura Legend?
A. Legislation in many countries require vehicles to have brake lamps. B. Your foot is on the brake pedal. C. There is a fault in the circuit
How do you change a starter on a 1993 Acura Integra?
To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.
Any Idea why losing tach signal intermitenly on 92 vigor check eng light comes on causes eng to go into limp mode wont go over 3500 rpm's we have already changed Crank Sensor?
i have the same problem with a 1993 acura vigor
Where is the starter located on a 1993 Acura Vigor?
The starter is hidden under the throttle body. Also very hard to get to, not to mention hard to see. I'd recommend having a professional do the dirty work.
