You have to remove the brake line making sure you have something to catch to fluid that will drain out. Plug to the line to prevent the system from draining completely. Remove/replace the brake line and refill the master cylinder reservoir and bleed the air from the system( if it is the hose at the caliper, you usually only need to bleed that wheel). If the reservoir drained completely you would have to run a ABS/bleed system test using a scan tool. After the air is all bleed out, recheck/top off the reservoir.
YesYes
I used this book and I change my pads in 45min. Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036
GET INTO THE TRUNK AND PULL DOWN THE CARPETING BY THE SIGNAL AND YOU WILL SEE THE BULBS JUST REMOVE AND REPLACE
You have a brake problem.
how to change front brake pads on a 2003 neon
Where is the engine management and ignition sensor on a 1999 plymouth voyager?
it is on the top of the steering colum
one.
A 1998 Neon uses DOT 3
Drum.
how do you put a Plymouth neon back in time 2.0L single overhead cam
4.5 quarts.