Well this is how my friend and I did it to put in some silverstar ultrabrights in my 03 Neon.
Open the hood and with a socket wrench remove the screws that attach the headlight casing to the engine compartment. Next remove the screws that attach the front bumper to the car (they're all on the top). With the "bumper screws" removed, pull out the headlight casing and bend/pull/warp the bumper as needed to remove the headlight. Its impossible if you dont remove the bumper screws trust me. With the head light hanging out, unplug the cord that leads to the bulb, unscrew the plastic ring that keeps the bulb in place, and GENTLY twist and pull the bulb out. And vuala! Just repeat the steps backwards to finish and repeat with the other headlight.
And DO NOT touch the glass of the bulb, the oil from your fingers will reduce the bulb's life by causing it to over heat, which will burn out your bulb sooner.
brighter headlights
change the bulb and fuse
To change the headlights on a 2005 Mitsubishi Colt, make sure there is no damage on the wire clip. Pull the bulb out gently. Slip in the new bulb and turn it until there is a click. Then put the clip back on.
make sure you fill up your headlight fluid after you change the bulb
There is no switch to change the headlights on an Impala. To change the headlights, you need to remove the dome coverings by gently squeezing in the clip at either side. The bulb will then be exposed for removal and replacement.
What all do I have to take off to get to the headlights. I just want to change the bulb can anyone help? Its a 1996 LHS.
The headlights on a 2005 Chevy Optra are changed by opening the hood, removing the wring harness from the headlight assembly and twisting the bulb. A new bulb can then be attached and the assembly locked into position.
I was looking at the 1996 Mercury Grand Marquis Owner Guide and it shows that you can change each of the ( 4 light bulbs for the 2 low beam and the 2 high beam headlights ) ( the low beam headlights take bulb # 9006 ) ( the high beam headlights take bulb # 9005 )
flip up the front headlights and remove them you should be able to reach in and replace the bulb
typically, you only change the bulb (it the bulb light is out). they usually cost a few dollars, if it is a busted headlight, do not know.
open hood, look at the side that the bulb is not working in, look just behind the headlights you nwill see a yellow handle, carefully pull it and it releases the turn signal assembly so you can change bulb.
There are several bulbs in the vehicle, and they all have different specs and methods of changing. For the headlights it require opening the bonnet and locating the light, opening it by removing the retaining clips and unplugging the faulty bulb. Which bulb do you need to change???