Want this question answered?
There are no individual bulbs, just LED's in the dials, and you will have to replace the entire instrument cluster.
to change the lights you remove the dash cluster and replace the bulbs. the number for the bulbs are 197
The bulbs are actually soldered into the circuit board. The only way to change them is to dismantle the whole cluster and desolder then re-solder the bulbs.
This requires you to pull the dash panel out - the bulbs are located behind that. You will need to remove the trim pieces around the dash - then the dash display itself. Good luck. Eric
To change the dash light bulbs you must remove the instrument panel.
easy
The 2003 Saturn Ion OBD 2 port is on bottom edge of dash; above hood release
Could be alarm...
What model of Corolla ? You have to take the dash board out and the bulbs can be removed and replaced from the back. The dashboard on the Corolla is not that difficult to take out, but you have to do it slowly and carefully.
It is practically impossible to reach up behind the dash to change the bulbs. Remove the trim around the instrument panal and you should be able to pull it out enough to change the bulbs. You may have to disconnect the speedometer to get it out far enough.
remove all bots that hold on dash look around everywhere even under the dash by your pedals drop the bottom part of dash off there should be 2 more bolts holding the top part of dash on remove dash and wiring from behind dash pull dash out of car remove your instament panel change bulbs remove all bots that hold on dash look around everywhere even under the dash by your pedals drop the bottom part of dash off there should be 2 more bolts holding the top part of dash on remove dash and wiring from behind dash pull dash out of car remove your instament panel change bulbs
take of ignition cowling .....2 screws and the clocks are out