answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change the distributor on a 1990 Pontiac Le Mans?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change an electrical fuel pump in a GM Optima or Pontiac Le Mans?

It is in the tank. Remove the tank then the pump. Not an easy job.


What are the release dates for MuscleCar - 2001 Pontiac Le Mans-Refurbishing the Frame?

MuscleCar - 2001 Pontiac Le Mans-Refurbishing the Frame was released on: USA: June 2007


How do you change the fuel filter on a 1972 Pontiac Le Mans and where is it located?

TAKE THE FUEL LINE OFF AT THE CARB.THAT RUN DOWN TO THE FUEL PUMP


How do you change the valves in a GM Optima or Pontiac Le Mans?

The head has to be removed then the valves removed, the seats ground and the valvs either ground or replaced.


How many feet long is a 1989 Pontiac le mans?

The 89' Pontiac LeMans is 12ft long


How do you install a fuel pump into a 1993 Pontiac Le Mans?

i have a 1990 lemans and it is located under my back seat you flip up the seat bottom and there is a flap of carpet there it may be the same on yours


How much horse power and torque does a 1973 Pontiac le mans have?

There were several different options for engines in the '73 Le Mans...


How many quarts of engine oil does a 1968 Pontiac Le Mans take?

5 quarts, run it and check level.Most Pontiacs take 6 with a filter change.


Were is the voltage regulator on a 1972 Pontiac LE mans?

It's inside the alternator.


Where is the location of the crankshaft timing sensor on a 1991 Pontiac Le Mans?

inside ditributer


What is the firing order for a 1988 Pontiac Le Mans?

The firing order for the 1988 Pontiac Lemans is 1-3-4-2. I hope this information to be useful to you


How do you locate and change the starter motor on a 1990 Pontiac Le mans Sedan?

The starter motor is about 8" long and cylindrical. It is found on the rear side of the engine, down low. Make sure that you disconnect the negative battery terminal first, because the power cable going to the starter is live. A couple of bolts hold it on to the bell-housing for the transmission.