After you open the hood the whole headlight assembly can be removed by taking off the the two black plastic wing nuts on top holding the headlight assembly in. There is also another wing nut like bolt that is between the headlight assembly and turn signal assembly that must be removed. One you do this you have to lift up on the headlight assembly to clear the threaded studs that the plastic wing nuts were on and pull both headlight and turn signal light assemblies straight out. They both have to come out together. There are some clips that still hold all of this in, but it will come out when you pull it straight forward. I have done this several times and it seems kind of tricky the first time, but actually is pretty easy.
how do i replace the drivers side headlight in a 2003 oldsmobile silhoutte
Open the hood of the engine compartment to your 1994 Toyota Corolla. Remove the wiring harness from the headlight. Remove the headlight retraining bolts from the headlight assembly. Reverse the process to install the new headlight.
If you're talking about the headlight, the "lens cover" is not a separate part, you need to replace the whole headlight assembly.
My drivers lens is all sctracthed and fogged up and my . # vsibility is causing me proublems
You remove the three plastic thumb screws and the headlamp it will come out along with the marker light, On the back of it will be a big plastic round cover turn it 1/4 turn and carefully pull it out. BE CAREFUL NOT TO TOUCH THE NEW BULB THE OIL ON YOUR FINGERS WILL SHORTEN THE LIFE OF THE BULB
in the bottom of the washer fluid reservoir over the battery on the drivers side near the headlight assembly
The drain plug is on the drivers side of the radiator. It is almost straight down from the headlight assembly.
The horn is located behind the drivers headlight. To remove unplug harness, undo bolt in bumper assembly behind drivers headlight (must be removed first), and it slides out. To install new, follow steps in reverse.
The horn is situated at the front of the engine compartment. The horn will be to the left of the drivers side headlight assembly.
Remove the headlight assembly to gain access to the parking light socket/bulb.
I need a headlight assembly for 87 Plymouth colt e. drivers side
Assuming you don't mean the actual buttons, but the control module itself. That would be located in the dash on the drivers side above the steering wheel assembly.