If you mean the HVAC fan, the resistor should be located within the fuse block.
how to replace blower resister on a 325i BMW 2002
To change out the blower motor in this car disconnect the battery ground and then carefully remove the long plastic cover that is mounted in the engine compartment at the top of the firewall. The blower motor is easily accessed as is the resistor board below it for the lower fan speed selections.
The blower resistor on the 1992 BMW 325i is located under the center console. It is found on the driver's side.
The blower resistor board is mounted underneat the blower motor. They are both accessible by taking off the long plastic cover at the top of the firewall from inside the engine compartment.
The 1990 325i has a M20B25 motor. The earlier 1990 525i had the same motor, a M20B25, whereas the later 1990 525i had a M50B25.
184 horsepower for the 2002 BMW 325i
2002 -2009 2010 - 2017
The heater motor in your car can be accessed by taking off the long plastic panel that runs along the firewall from inside the engine compartment. Disconnect the battery before unplugging it. Below it is the resistor board that holds resistors for the 1 through 3 speeds.
yes no problems......u might have to change the fuel rail????or cpu??the 94 i yhink it is a veinos motor and the 92 is non veinos...
5x120
1995 BMW 325i 6 cycl motor oil drain plug location?
At the bottom of the oil pan.