0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is acceleration the rate of change of the rate of change of position?
no its speed that definds the rate change of position
What is relation between feed and rpm?
Feed Rate = No of Cutting teeth x RPM x Feed per tooth.
Speed is the rate of change of position expressed as what?
Speed is the rate of change in what?
The velocity of an object is the rate of change of its position What is it?
Velocity is the rate of change of the position of an objec
Rate of change of velocity of a moving object?
The rate of change of velocity is termed acceleration.
Why do pellets build up in the fire box of my pellet stove?
Pellets will build up for numerous reasons. First thing I would check is the air flow settings on your pellet stove. If it is too low not providing enough air the pellets will not burn fast enough causing them to pile up. Another possibility is that the feed rate is set too high on your stove. I would recommend cleaning out your stove really well, removing all the ash and trying to see if they pile up again. You really have to mess with your feed rate and your air controls to get the proper settings where it runs smooth.
What is the electrical cost to operate a pellet stove?
It depend on what type and model the stove is. A typical unit draws about 300 watts. If it has an electrical starter it will have another 150 watts added to the total until the pellets ignite and then it shuts off.So lets say it draws 300 watts or .300 kW. In one hour it will draw .300 kW hours. Next you have to state what your cost for a kilowatt hour in your area.As an example lets use .09 cents for a kilowatt hour. Multiply this .300 x .09 = .027 cents an hour.Take this hourly rate times the amount of hours the stove is operating and this will give you the total cost of operating the pellet stove over a specific amount of hours.
What is the feed rate for cutting double lead threads?
Your feed rate depends on the pitch of the thread i.e. 16 TPI =a feed rate of .0625 To cut a double lead thread you need to either rotate the part 180 deg. for the second thread or change the start point by pitch /2 1/16=.0625 .0625/2= .0312 so your second thread will start .0312 from the first thread.
Is acceleration the rate of change of the rate of change of position?
no its speed that definds the rate change of position
What is the percent rate of change?
The rate of change is the change divided by the original value. This answer, converted to a percentage is the percentage rate of change.
What is rate of acceleration?
The rate of change of velocity. (As velocity is the rate of change of position.)
Why does the rate of heartbeat change?
Why does the rate of heartbeat change?
What is relation between feed and rpm?
Feed Rate = No of Cutting teeth x RPM x Feed per tooth.
What is the most powerfull bb gun?
If you are asking strictly about BB guns and not rifles, pellet guns or pellet rifles then I would have to say it most likely is the "IZH-Baikal Drozd BB Gun." It fires at a rate of 541 feet per second. It will fire 1, 3 or 6 shot burst at the pull of the trigger. However Pellet guns and Pellet Rifles are more powerful.
What is a rate of change expressed as a percent?
It is the percentage rate of change!
What is the geometrical meaning of second derivative?
The first derivative is the rate of change, and the second derivative is the rate of change of the rate of change.
How is the steepness of the line is related to the rate of change?
the steepness of the line is the slope of the line which is the rate of change; the steeper the slope, the faster the rate of change
