very easy, behind the caliper are 2 bolts, soak them with dubD-40 or equivalent.
remove bolts (be sure to remove at counter clockwise cause you might get confused due to it is in the inside.
twist caliper toward you and forward so it come if easier, get a nice size clap that will reach behind the housing and in front of piston turn till it is flat with the caliper.
take spindles (Rotors) too local auto shop that turns em or machine shop.
slide spindle back on lug bolts...
put pads in caliper and slide onto spindle.
align bolts and tighten
after assembly pump brakes slowly a few times so the engage,
High Hoe Silver..... that's it
2001 Buick need to change the front brakes, I want to make sure there are no sensors or anything before removing them.
How to change brake lines on a 1991 Buick Lesabre?
The 2001 Buick Century brake light switch is located beneath the dashboard, on the drivers side. The brake light switch should be labeled as such.
Its actually a torex head you need... not sure of size yet. Its a T-50 Torex.
Have you checked the fuses?
Remove the tire, brake caliber and the rotor should side off the hub.
This is how you do it. First you have to say that wikianswers sucks, then you have to say that you want to kill your mother, then you just have to kill more people on earth.
Remove the two bolts that hold calliper to bracket and disconnect brake fluid line. The bolts are probably metric #15. Bolt new calpers back in connect brake line and you will need to bleed brakes to remove air from system.
Make sure the parking brake is completely released. If the parking brake is on the Highlights go off.
The correct size is 3057.
On my 1990 Buick Regal, I need an 18mm wrench , a 10mm wrench, screwdriver, jack, and a can of brake cleaner
Loose contacts or your sensor may be stuffed - see an auto electrician