Remove the tire and wheel from your 1994 Chevy. Remove the brake assembly. Tap on the rotors with a hammer or mallet. The rotors will slide off. Reverse the process to install the new rotors.
jack it up remove the wheel then the brake calipers then the rotors should slide off
Remove the tire and wheel from your 1996 Chevy Cheyenne. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
warped brake rotors, have them resurfaced.
Change front brake rotors on a 1998 Hyundai Accent?
Purchase a repair manual for that vehicle from your local auto parts store if you are not familiar with brake repair.
Take off the tire, remove the brake caliper, and pull off the rotor.
The brake rotors are warped are out of round. Need to do a brake job and have the rotors turned are replaced. Be sure to install new pads and shoes.
The 1981 Chevy Cheyenne brake fluid tank can be found attached to the firewall in the engine compartment. The brake fluid tank will be on the drivers side of the firewall.
Change the brake rotors
To change the brake rotors on a 1991 Honda Civic raise the vehicle. Remove the wheels and brake caliper bracket. Remove the brake pads. Loosen the rotor mounting screws and replace the rotors.
remove the brake caliper and the rotors come right off
As long as your rotors are not warped, or you have not let the brake pads wear to the point they defaced the rotors, there is no need to change them. Just install new brake pads. Rotors can last the life of the car.
Remove the brake assembly from your 2000 VW Beetle. Tap on the rotors with a hammer or mallet until the become loose. Slide the brake rotors off. Reverse the process to install your new brake rotors.
Need to know if it is a 4+2 or a 4+4.
It can be easy to change the brake rotors. Lift the car, remove the tire, brake shoe and rotor, put on the new rotor, replace the brake shoe, tire and lower the car.
Remove the tire and wheel from your 1993 Chevy Lumina. Remove the brake assembly spring and the brake caliper. The brake assembly will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to change the new rotor and brakes.
take the wheels off, unbolt the brake calipers and the pull them off and now you can just pull the rotors off.
The brake rotors are warped. Machining or replacement of rotors necessary to correct that.
Need to know if this is a 2 wheel or 4 wheel drive S10.
There should be two rotors if your truck is 2wd. They are located where the brake pads clamp to. Rotors are also called brake disc. It's the round disc between the brake pads.
You have a warped brake rotor(s). Resurface or replace the effected brake rotors.
When rotors need to be changed usually the pads have worn down. It is always a good idea to change pads when changing rotors.
Purchase a repair manual at any auto parts store.