First jack up the car so the tire is off the ground. remove the wheel. get a wire or rope. take out the 2 bolts that attach the brake to the hub. wire up the brake and rotor( or maybe set aside the rotor) so they're out of the way. Remove axle nut (takes a big socket) and the 3 bolts that hold the wheel bearing into the hub. push the axle back and pull the wheel bearing and sensor wire out (takes some manipulation). Reverse order to reassemble I don't have the torque specs. This is an outline but it's what I did. I didn't use a torque wrench, just made the nuts and bolts tight as I thought I could without stripping anything. The hub bolts are hard to get in and out without messing up the bolt heads. good luck
160Nm (118 lb. ft.) according to the service manual.
In the 2001 Oldsmobile Aurora, the horn is located under the left headlamp on the left front corner of the car. The Oldsmobile Aurora midsize sedan that was launched in 1995.
yes, all auroras are front wheel drive only
how change front strut on1995 Oldsmobile catlass suprime
how do i change front wheel bearing of kia sorento 2003
How do you change a 1998 jimmy 4X4 front wheel bearing ?
Directly in front of the driver's side front tire inside fender well.
2. front left and front right.
pull front of rear seat up. remove it and battery is right there
Right in front of and slightly to the side of Throttle body
The 1995 Oldsmobile Aurora cooling system temperature sensor can be found on the front of the engine. The sensor will be above the thermostat housing.
Front passenger side of engine bay in fuse box.