The inline fuel filter is located under the right frame rail where the right back door is. you will need to jack up the car at the rear jack point, and unscrew the gas cap. Have a rag and a bucket ready in case some fuel comes out. You will need to unbolt the clamp with holds the fuel filter to the frame first. Have the bucket ready, and with your fingers squeeze the quick disconnect fitting on one side of the filter and let the fuel drain into the bucket. Then repeat the squeeze on the other side of the filter to release the other side. Reinstall the clamp which holds the fuel filter to the frame in exactly the same spot as the old filter. Watch the arrow of flow on the old filter and install the new filter exactly the same way. Keep in mind, the vehicle will not run if the filter is installed backwards. Fuel flows from the gas tank (back) to the engine ( front). Make sure new filter snaps in to each fitting well before bolting the fuel filter down. Once this is complete don't forget to screw the gas cap back on and start the engine to make sure there aren't any leaks.
5 quarts with a filter
buick roadmaster 1992 rear axle does it have limited slip diff
Buy the Chiltons or Haynes manual. It will walk you through the process.
350
The answer to this is too complex and you need special tools...sorry..Rick D
A 1992 Buick does not have an inertia or fuel cut off switch.
Need to now
On the frame rail in front of the rear wheels. Can't remember rt. or lft. side. Rick D.
No. It's 1.5 din.
its a 350hp vortec engine.
180 hp
rear wheel drive