0
On Composite Headlights, You will need to remove the 6 screws and 4 clips holding your grill on . After you removing the grill. You will see 2 rod type bars you will need to unscrew on each headlight. Then the headlight housing will fall out so you can replace your high or low bulbs.
What else can I help you with?
Does the head gasket a on 1999 Chevrolet Blazer need to be replaced as a maintenance item?
no
Change head gaskets 97 Chevrolet blazer?
Head gaskets are changed on a 97 Chevy Blazer by removing all engine accessories, taking off the intake manifold, removing the valve covers, and taking out the retaining bolts. The heads can then be lifted, the gasket removed, and a new gasket put in place.
Where is the fuel rail on a 95 blazer?
The 1995 Chevrolet blazer fuel rail is located inside of the valve cover. The fuel rail runs the length of the cylinder head.
Where is the oil filter located for a 1995 Chevrolet Blazer?
left front fender area behine the head light
How do you change a 1998 Ford Explorer head gasket?
How do I change the head gaskets on my 1998 ford explorer?
Where is the temperature sending unit located on a 1996 4.3 Chevrolet blazer?
It is in the driverside head between the first 2 spark plugs.
Where is the engine temperature sensor on 2001 Chevrolet Blazer lt 4.3 liter vortex engine?
It is on the driver's side head by the back spark plug.
Where is the engine coolant temperature sensor on 2002 v-6 vortec motor Chevrolet blazer?
It is on the right head beside the back spark plug.
What causes temperature fluctuations in a 1998 Chevrolet truck?
Bad thermostat, Low on engine coolant--( coolant leak ) Cracked head, Leaking head gasket,
How do you change head light bulb on Chevy trail blazer?
The answer is detailed very well at our enthusiasts forum at www.trailvoy.com
What is the location of cyl 1 on a 1998 Chevy s-10 blazer with a 4.3 v6 motor?
That would be the front spark plug in the drivers side head.
How much will it cost to fix a head gasket on a 1998 Chevrolet Camaro if you take it to a shop?
To pressure test the head, resurface it and grind the valves with parts and labor, you will be looking at $900.00 to $1,200.00.
