Pull out the rubber socket . No need to twist or anything, it comes straight out once you apply enough force. Then pull out the rubber boot (grab the tab at the top and pull it out from the topdown). There is a retaining clip that you need to push down to unhook one side and then pull that side of the clip like a hinged door to access the light bulb. You can then remove the bulb and replace with a similar type. Check that you orient the bulb correctly. The lamb assembly has three slots the the bulb fits in for that purpose. Then rotate the retaining clip back into position and push down slightly to latch the free end back in place. Replace the rubber boot (from the bottom up) and ensure that the bulb's electrical connector is clear. Push the rubber socket back into the bulb's connector and you're good to go.
how to replace wiper transmission assembly on a 2001 tracker
You will need to take the complete headlight assembly loose or out to get to the bulb to change it.
on top of headlight assembly, there are 2 tabs to pull up, then pull assembly out.
Open the hood and then examine the top of the headlight assembly and locate the two pins that can be pulled up and out of the assembly. Then rotate the headlight Assembly out of the front of the grille and change the headlight bulb...reverse the process
It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!
Turn signal lever.
Open the hood. On top of the headlight assemblies, there's a curved metal rod. Pull that out, and you can pull the headlight assembly right out. From there, you turn the bulb ballasts counterclockwise and pull them out, and you can either replace the bulbs at that point, or the whole headlight assembly if necessary.
How do you change the front rotors on a 2004 Chevy tracker
Open the hood, stand in front of headlight, notice two black tabs sticking up behind the headlight assembly in back of the radiator support. Pull these two tabs straight up and off. This will unlock the headlight assembly. Now you can wiggle the assembly out the front and gain access to the bulb. Reverse for assembly.
Stand in front of the headlight in question, with hood open notice two black tabs sticking up behind headlight bucket assembly. Remove the two tabs by lifting straight up. The headlight bucket assembly can now be wiggled out of the car and you can now remove the bulb socket from the assembly to replace the bulb. Reverse order for assembly.
Pull the complete headlight assembly out to get to the bulbs. You first have to pull the front bumper off, along with the wheel well to get to the headlight assembly.
Open the hood & look for two white sliding clips. Pull them up to remove them. The headlight assembly should easily pull out. Identify the wiring harness & unclip it. Reverse the procedure to reinstall