Hi
open the boot
this reveals there a 4 screws down the vertical
(edge 2 on the light cluster
2 on the lower coloured bodywork edge moulding)
undo all 4 (black screws) you can see
gently lift out the cluster (on the outside edge of the car there are some retailing holes that help the light locate)
it feels like you are removing half the rear of the car! be gentle and it will come backwards
undo central light power clip
undo lower fog light powr clip
this should enable you to remove entire cluster (the corner of the car, well most of it!)
then there are two screws visible on the inside of the light cluster (silver screws)
remove these
unclip rear black moulding on lightcluster and this carefully hinges at botton
where two other clips need to be eased
revealing all bulbs
its a pain in the bum job but not impossible once you get the idea
it goes back easier than it comes out.
presumable they want to keep it as main dealer job!
OPEN BONNET ,GO TO THE SIDE OF THE CAR YOU NEED TO GET AT , CLIP OFF THE HEAD LIGHT MAIN BULB CASE , PULL OUT THE HOLE LIGHT WITH SILVER BASE. IT VERY EASY
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?
How to change headlight bulb 2011 ram 3500
To change one's back headlight, one must first uncover the light bulb. Then one must unscrew the bulb. One must have another bulb to change the headlight. Screw in the new bulb.
To change the odometer bulb in a 1959 plate meriva is very easy. All you have to do is take the four 8mm bolts out that hold on the cover on, on the back of the odometer gauge pull out the bulb, disconnect from wiring attach new bulb and put everything back together.
you will probably have to take the complete headlight assembly out to get enough room to change the bulb.
To change the headlight bulb on a Pajero Shogun, open the engine compartment hood. Locate the back of the headlight and twist the bulb off. Replace with new.
You cannot replace the headlight bulb. You need to buy a new headlight unit.
How do I change the nearside headlight bulb on my Vauxhall Vectra 2007
All you will need to change the bulb is a screwdriver and a new bulb. Remove the headlight cover using the screwdriver and remove the burnt out bulb. Once out, you can insert a new bulb into the slot and replace the headlight cover.
Could you please tell how I change a headlight bulb for my Volkswagen T4 panel van
For the 1994 model (B3000), you can't change just the bulb. You have to change the headlight assembly.