ou have to remove the headlight assembly by removing the two screws on top and pull out the assembly. The screws will be long. After you remove the headlight assembly there is two sets of wires one for your turn signal and one for your headlight grab a hold of the headlight up close to the assembly and turn it. when you have turned it enough it should be able to come out then you put the new bulb in and reinstall everything.
Plymouth Breeze was created in 1996.
Get a manual on your car from AUTOBOOKSONLINE.COM
you have to replace the t.p.s (throttle positioning sensor ) that's how i fixed the idle on my Plymouth breeze
Which drain plugs?
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
Get a manual on your car.
On the bottom of the oil pan.
Plymouth does not use inertia/reset switches.
Engine and trans out the botom at the same time.
no special tools are needed
the sensor is probly bad or you have short in it
Use a measuring tape! Or take them off and compare... Seriously?!
Like any other auto batttery. Side post or top post.
Code 7 2 is catalytic converter efficiency below required level
bad or dirty float on the fuel pump in the gas tank.
try transmission sensors
Mopar ATF+4Mopar ATF+4
It does not have a cabin filter.
It is located on the discharge side of the compressor. On a 2.4L engine you will need to jack the vehicle up to get to it.
Recommended tyre pressures are usually marked on the walls of tyres near the brand name.