The bulb replacement is quite simple. You need a standard screwdriver and a phillips. Take the standard screwdriver and pry the two panels off of the side of the light. You don't need to use much force as these are only clipped in. Next unscrew both screws from the light on either side. Once the screws are loose, the light will tilt forward. Lift the light up as you remove it. The light bulb is on the right side and requires about a 1/2 turn towards you before it slips out. The factory bulb is a Stanley 921 - 12volt 18watt bulb. You should be able to find this at your local auto parts store. The bulb simply pulls out, no need to twist. Replacement is the reverse. I suggest using a kleenex or a cotton cloth on the bulb to avoid any fingerprint marks which may shorten the life of the bulb. Twist the socket away from you to tighten. Angle the light down to insert back into the space. Tighten the screws and gently push the two screw covers back into place. You may need to apply a little bit of pressure to side to squeeze them back into place. You're done!
Original equipment part for brake light replacement on 2000 Honda Odyssey EX is: 7443 W21/5W STANLEY 12V 03U E4 2DW
Check the level of brake fluid in the master cylinder Make sure parking brake is fully released
2 things could be the problem. If the "Brake" light is on that usually comes on when you set the parking brake then it could be the brake fluid is low. Check that. If it is the "Brake Lamp" light then check your brake lights. 1 of them could be out.
If it is the upper brake light and it is similar to my 99 Odyssey, there is a small square cover on the side of the red plastic lens. Beneath that cover is a screw used to remove the lens, exposing the bulbs. My dealer has snapped off this plastic clip once already, so be careful removing it.
Bad or misadjusted stop light switch
Assuming you mean brake lights, the brake light switch is broken or out of adjustment.
there is 2 plastic pieces (red) on either side of the light remove those, careful they break easy then two screws pull it off, and replace the bulb
That means time to change transmission
just had oil change on saturday. no problems. now brake lamp light on 2000 honda accord ex
Honda odessy abs light on when driving
To change the brake light bulb on a 1999 Honda Passport find the light housing located in the trunk. Find the plastic covers for the lights and remove them. Pull the bulbs out carefully and replace them.
this could be the cause of low brake fluid or that your foot is on the brake and it is indicating that the ABS is working.