0
on the left side front of engine there will be 3 coil packs in a line. take the two screws off each coil pack and fold coil pack back and module will come free from under coil packs you will then need a 7mm nut driver to take loose wiring harness.try to remember to put heat displacement material on new module .it gets pretty hot there
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change ignition cylinder on 2001 Monte Carlo?
how do i change a ignition cylinder on a 01 Monte Carlo
How do you change radiator in Monte Carlo ss 2001?
how to change a radiator in 2001 Monte Carlo
How do you replace an ignition switch on a 2001 Monte Carlo ss 3.8?
Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
How do you change the outer tie rod in a 2001 Chevy Monte Carlo?
how due you vhange a inner and outer tie rod on a 2001 Chevy Monte Carlo
How do you change coolant sensor on a 2001 Monte Carlo?
See a dealer
How to remove engine 2001 Monte Carlo?
how to remove the engine of the 2001 monte carlo step by step
What are the ratings and certificates for Monte Carlo - 2001?
Monte Carlo - 2001 is rated/received certificates of: Australia:M Netherlands:12
How often should you change fuel filter on a Monte Carlo 2001 SS?
Change it every 50,000 miles.
How many oxygen sensors is on on a 2001 Monte Carlo ss and what is bank 2?
There are 2 oxygen sensors on a 2001 SS Monte Carlo.
How do you change the front wheel bearing on a 2001 Chevy Monte Carlo?
Like you change the tires on any other car...
Where is the Body Control Module located on a 2001 Chevy Monte Carlo?
were is the bcm located on a 2000 monte carlo
Where is the low coolant sensor on a 2002 Monte Carlo?
On a 2001 Monte Carlo it is located on the radiator just below the radiator cap.
