I have a 2002 Chevy Malibu. I did this myself in about 30 mins. First you must disconnect the battery. After the battery is disconnected, remove the trim around the radio by pulling the panel off which is held on by small snap in tabs. Next remove the radio by removing the three 7mm head screws. Pull the radio toward you and set aside. No need to disconnet wires. You can now see the side of the ignition. At this point put the key in the ignition. Now looking at the side of the ignition you will see a rectangle metal tab recessed in the cylinder. Turn the key slowly toward the on position. At the same time apply little pressure on that metal rectangle spot. It will push in some where between acc and start. When it pushes in, with the key where it is pull outward this will allow you to slide the ignition out the key will stay in the ignition. Next remember there is a chip in the ignition. When the new one is installed the car won't start. If it does it will stall out. leave the key on and wait till the theft light which will be blinking goes off. Your programming the car to regonize the new ignition. This will take about ten minutes for it to stop blinking. Once off retry starting the car, you might have to do this up to three times before it regonizes the new chip. It only took one try with my car. Jeff
Oakley,MI
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
This question does not make sense. More information is needed.
Remove the belt from your 1999 Chevrolet Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining nuts. Reverse the process to change to the new alternator.
how do i change a ignition cylinder on a 01 Monte Carlo
I doubt it very much as they change engine specs every year.
You can change the ignition cylinder on your 1999 Mercury Mystique by removing the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness.
I'm not a mechanic
You can change your 1995 Chevrolet ignition switch by removing the ring at the top of the ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
i need the bracket that the ignition cylinder slides into.... the piece that mounts to the stering column
Remo0ve oil pan for access
there is no gearbox. get a haynes manual. rack or pump.