ok well in my twin turbo you would just have to take the water lines off the back and reach under the intake manifold on the back side, {if you have enough room}
that the knock sensor does
how do you change the knock sensor in a 2003 Chevy silverado 5.3
were is knock sensor on 3.1 cutlass supreme
how much does it cost for labor to change a knock sensor in a 2002 toyota siennna van
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
The knock sensor is under the intake manifold, which has to be removed. This should be left to an experienced mechanic.
need change knock sensor 2 bank 2 in 2000 lexus rx300
Not much goes wrong with them! if your car is pinging under load this may be a bad knock sensor, but if you tap the block with a small hammer & the idol seems to change or the timing wanders this is the knock sensor failing. if the idol doesn't change this is a bigger issue
LS does not have a knock sensor. GSR does have a knock sensor
The knock sensor has failed and you need to replace it with a new one in order for the check engine light to go out.
where is the oxygen knock sensor located on a 3000 v6 Jaguar engine 2002 model and how can i change it?
It is not necessary to change those gaskets if all you have done is change the knock sensor. If they seem to be worn then you probably should go ahead and install new ones.