The procedurte involves removing the entire dash display in order to get to the bulbs. Not an easy or simple task. My question to you would be, just how necessary is it for you to osee the mileage at night?
IF you decide it's necessary, my adivce would be to replace EVERY light bulb in the dash display, because if one has failed the others cannot be far behind.,
With the ignition key off, press and hold the odometer reset button, and turn the ignition on and do not start the car. In about 2 seconds the light will reset.
Two reset the maintenance required light on a 2005 Honda Accord all you have to do is hold the odometer reset button on the gage panel for about 30 seconds while the key is in the on position. Not running just in the on position. it will reset.
It shows the intrument brightness control is changed by turning the odometer reset button.
HOPE THIS HELPS...ON MY ACURA(TOP-FLIGHT-HONDA) THERE IS A MAINT. REMINDER ON THE DASH THAT TURNS AMBER AT MAINT. INTERVALS. YOU STICK YOUR MAIN IGNITION KEY INTO A RESET SLOT NEAR THE LIGHT, AND THIS TURNS THE LIGHT FROM AMBER BACK TO GREEN. I THINK IT WORKS OFF OF THE ODOMETER ....GOOD LUCK! ..BB
Press and hold the odometer reset button while turing the ignition switch on without starting the engine. After 5 seconds the light will go out.
on the odometer there are 2 buttons press right and turn ignition without release this button 10 second light turn off
How do i remove the tail light on a 2005 Honda odyssey to rpleced the light bulb.
How do you change the differential (rear) in 2005 Honda CRV
Press and hold the odometer reset button in while at the same time turning the ignition switch to the on position. Do not start the engine. After around 5 seconds the light will reset.
Press and hold the odometer reset button while at the same time turning the ignition switch to on. Do not start the engine. After around 5 seconds the maintenance required light will go out.
With the ignition off, push and hold to odometer reset button in while at the same time turning the ignition to the on position without starting the engine. After about 5 seconds the light will go out.
Turn vehicle off. Press and hold down the trip/odometer button while turning the ignition back on. Hold for 10 seconds.